YYYYMMDDH1_A.nc - Original 1Hz netCDF file with all flight level measured and derived parameters
YYYYMMDDH1_AC.nc - Calculated 1Hz netCDF file with all flight level measured and derived parameters using updated calibration coefficients
YYYYMMDDH1_AX.nc - Calculated 1Hz netCDF file with all flight level measured parameters and corrected measured parameters using updated calibration coefficients
YYYYMMDDH1_AXC.nc - Calculated 1Hz netCDF file with all flight level measured parameters, corrected measured parameters, and derived parameters using updated calibration coefficients.
YYYYMMDDH1_selParams.txt - File describing the parameters used information used to compute Meteorological Variables
YYYYMMDDH1_ES.pdf - Error summary report for the final Quality Controlled data set.
YYYYMMDDH1_A_Raw.nc - Original multi-Hertz netCDF file with non-translated digital packets containing all measured parameters
YYYYMMDDH1_A_Raw_1Hz.nc - Original 1Hz netCDF file with all measured parameters
YYYYMMDDH1_FST.nc Original multi-Hertz netCDF file with all measured and derived parameters
YYYYMMDDH1_A_FDlog.dat - Flight Director's in-flight log file
YYYYMMDDH1_GapReport.dat - File generated by the data system stating when there were gaps in the data
YYYYMMDDH1_A_IWG.dat - ASCII 1Hz flight level data measured and derived parameters.  (not all measured and derived parameters are included)
YYYYMMDDH1_A_NOVATEL.dat - NOVATEL GPS data file
YYYYMMDDH1_A_OZONE.dat - Ozone data file
YYYYMMDDH1_A_SFMR.dat - File generated but no data collected
YYYYMMDDH1_serial.dat - ASCII 1Hz flight level data measured and derived parameters.  (not all measured and derived parameters are included)


After the aircraft returned to MacDill AFB, a few instruments that were installed on N42RF were removed and calibrated in the AOC calibration laboratory.  The final Quality Control data sets use the post project calibration coefficients for determining the output of the instruments.
The following parameters that have been updated from the original data set follow.

PDALPHA.2 - Radome Attack Differential Pressure Measured
PDBETA.2 - Radome Sideslip Differential Pressure Measured
PDALPHA.1 - Fuselage Attack Differential Pressure Measured
PQALPHA.1 - Fuselage Attack Dynamic Pressure Measured
PDBETA.1 - Fuselage Sideslip Differential Pressure Measured
PQBETA.1 - Fuselage Attack Dynamic Pressure Measured
PQM.3  - Measured Fuselage Dynamic Pressure, Two Sources --co-pilot
PQM.4 - Radome Dynamic Pressure Measured
TTM.1 - Measured Total Temperature Degree 
TTM.2 - Measured Total Temperature Degree 
Any derived value using the outputs from the measured parameters listed above have changed slightly from the values measured in real-time.

Novatel file description:
If Log header = GPGGA
Log Header, Latitude, Latitude Direction, Longitude, Longitude direction, GPS quality, # of satellites, Horizontal dilution precision, Altitude, units, Age of Differntial GPS data in seconds, Differntial base station ID*checksum


If Log Header = GPGSA
Log Header, Mode (Automatic 2d/3d or Manual 2d or 3d), Mode (1-Fix not available, 2 = 2d, 3=3d), Position dilution precision, , Horizontal dilution precision, Vertical dilution precision*checksum

If Log Header = GPGST
Log Header, rms value of Standard Deviation of the range inputs to the navigation process.  Range inputs include pseudoranges and DGPS corrections, Standard Deviation of semi-major axis of error ellipse (m), Standard Deviation of semi-minor axis of error ellipse (m), Orientation of semi-major axis of error ellipse (degrees from true north), Standard Deviation of latitutde error (m), Standard Deviation of Longitude error (m)*Checksum